Vwalla Wall Panels are designed to be assembled by you.
That way, you save the most money. Check out the easy installation steps below!
- Vwalla 3D wall panels
- Adhesive gun
- Paint (Optional)
STEP 1 : SURFACE PREPARATION
Vwalla wall panels are made for relatively flat and smooth surfaces. Ensure that the surface is clean, dry and free of loose debris before installation.
STEP 2 : INSTALLATION PLANNING
Start with a full wall panel and work into the corner, or start from the centre and work outwards towards both corners.
STEP 3 : MEASUREMENTS
Use a leveler, measuring tape or ruler to mark the walls with guidelines to ensure proper positioning.
STEP 4 : ADHERING ONTO WALL
Apply adhesive evenly to edges and back of the wall panel. Remove any excess adhesive with a damp cloth.
Press the edges firmly against the wall and apply pressure for 1-2 minutes.
STEP 5 : TRIMMING WALL PANEL
You will most likely be required to cut the wall forms.
Use a standard pen knife to cut, then sand the cut edges for a smooth finishing.
STEP 6 : PAINTING WALL PANEL
Allow the wall forms to dry for 24 hours.
Ensure the surface is free of dust before applying water or oil-based paints.
That's it! Ditch mediocre walls for designs of superior quality. Browse our catalogue of 3D wall panels today!